MakerBot Replicator 2 Manuel d'utilisateur télécharger pdf (Page 28)

Push down on the extruder arm.

Continue to hold it down as you insert the

free end of the ﬁlament into the hole in the

top of the extruder. Push the ﬁlament in as

far as it will go. You will see plastic start to

emerge from the extruder nozzle.

Release the extruder arm.

Push the Filament into the Extruder

LOADING MAKERBOT PLA FILAMENT CONTINUED

The extruder motor will grab onto the

ﬁlament and continue to draw it in. Watch to

make sure plastic is still extruding from the

nozzle aer you release the extruder arm.

Then press the M button to stop extrusion.

NOTE: Don’t be surprised if the ﬁlament that

initially comes out of the nozzle is not the color

you expected. There’s probably some ﬁlament

inside the extruder le over from our testing

process at the MakerBot Factory. Wait until you

see the color that you loaded come out of the

nozzle before you press the M button.

Stop Extrusion

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Pas de commentaire

MakerBot Replicator 2 Manuel d'utilisateur Page 28