MakerBot Replicator Manuel d'utilisateur télécharger pdf (Page 23)

startup23

FIRST STEPS

CONNECT TO YOUR COMPUTER

There are three ways to move ﬁles from your computer to your MakerBot Replicator: USB

cable, Ethernet, and USB drive.

To connect via USB cable:

1. Remove the USB cable from the accessory box.

2. Insert the USB-B end of the cable into the port on the back of your MakerBot Replicator

and insert the USB-A end of the cable into a USB port on your computer.

To connect via Ethernet:

1. Locate an Ethernet cable (not included).

2. Connect one end of the cable to the Ethernet port at the back of the MakerBot Replicator.

Connect the other end to a wall jack or router used by your local area network.

To connect via USB drive:

No additional setup is required. See Chapter 4 for instructions on exporting print ﬁles.

Once you’re connected, download MakerBot Desktop to complete setup of your MakerBot

Replicator.

Note: Your MakerBot Replicator 3D Printer is also set up for built-in Wi-Fi connectivity.

We will be enabling onboard Wi-Fi with a ﬁrmware update soon.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 60 61

Pas de commentaire

MakerBot Replicator Manuel d'utilisateur Page 23