MakerBot Replicator Z18 Manuel d'utilisateur télécharger pdf (Page 17)

GETTING STARTED17

3 REMOVE ACCESSORIES

UNPACKING THE MAKERBOT REPLICATOR Z18

Take the accessory and ﬁlament boxes out

of the MakerBot Replicator Z18 and set

them aside.

4 TAKE THE MAKERBOT REPLICATOR Z18 OFF OF THE PALLET

Li the MakerBot Replicator Z18 o of the

pallet and place it on a stable surface.

You will need to remove the lid of the

MakerBot Replicator Z18 in order to load

ﬁlament, so make sure the surface is low

enough to allow you to access the top of

your 3D printer.

Caution: Two people are required to li

the MakerBot Replicator Z18. Do not li

alone. To prevent injury, li with your legs,

not your back.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 66 67

Pas de commentaire

MakerBot Replicator Z18 Manuel d'utilisateur Page 17