MakerBot Replicator Z18 Manuel d'utilisateur télécharger pdf (Page 29)

STARTUP29

FIRST STEPS

CONNECT TO YOUR COMPUTER

There are four ways to move ﬁles from your computer to your MakerBot Replicator Z18:

Wi-Fi, Ethernet, USB cable and USB drive. Before you proceed, set up your computer to

connect using one of these methods.

To connect via Ethernet:

1. Locate an Ethernet cable (not included).

2. Connect one end of the cable to the Ethernet port at the back of your MakerBot Replicator

Z18. Connect the other end to a wall jack or router used by your local area network. MakerBot

Desktop will automatically detect your MakerBot Replicator Z18 during soware setup.

To connect via USB cable:

1. Locate the included USB cable.

2. Insert the USB-B end of the cable into the port on the back of your MakerBot Replicator

Z18 and insert the USB-A end of the cable into a USB port on your computer. MakerBot

Desktop will automatically detect your MakerBot Replicator Z18 during soware setup.

To connect via Wi-Fi:

1. Locate the included USB cable.

2. Insert the USB-B end of the cable into the port on the back of your MakerBot Replicator

Z18 and insert the USB-A end of the cable into a USB port on your computer. MakerBot

Desktop will automatically detect your MakerBot Replicator Z18 during soware setup and

use the USB connection to connect it to your Wi-Fi network.

To transfer ﬁles via USB drive:

No additional setup will be required. See Chapter 4 for instructions on exporting print ﬁles.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 66 67

Pas de commentaire

MakerBot Replicator Z18 Manuel d'utilisateur Page 29