MakerBot Replicator Z18 Manuel d'utilisateur télécharger pdf (Page 57)

TROUBLESHOOTING57

LEVELING THE BUILD PLATE

The build plate on your MakerBot Replicator Z18 is leveled at the MakerBot Factory and

locked into place, but over time it might shi slightly. If you observe that your prints are

consistently peeling o of the build plate, you may need to level the plate again.

Before leveling your build plate, unload any ﬁlament, clear debris from the extruder nozzle

and build plate, and allow the Smart Extruder to cool.

1. Begin the leveling process by navigating to

Utilities > Level Build Plate on the control

panel of your MakerBot Replicator Z18.

2. Use the 5 mm hex wrench that came with

your MakerBot Replicator Z18 to loosen the

four bolts locking the build plate in place.

3. Tighten the two front leveling knobs all

the way.

Locking

bolts

Front le

leveling knob

Front right

leveling knob

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 66 67

Pas de commentaire

MakerBot Replicator Z18 Manuel d'utilisateur Page 57